Enigma simulator install#
Enigma simulator drivers#

Exit the Serial Monitor, otherwise MoonJS cannot connect to an open serial port.ģ) Install modified copy of MoonJS on host computer. Sending lowercase a and q will turn those indicators off. Type Q and press Send and the 'COMP ACTY' indicator should illuminate. On the Top Line of the Serial Monitor type A and press Send, the 'UPLINK ACTY' indicator should illuminate. Click Tools -> Serial Monitor and on the bottom right of the screen, select 9600 baud. Click Tools -> Port and select the newly created port. Click Tools -> Board -> Arduino/Genuino Mega or Mega 2560. Communication can be verified by launching the Arduino Software.

Enigma simulator drivers#

The host computer will install the serial port drivers and assign a serial port number to the Arduino Mega. Connect the other end of the cable to the host computer.

The Two Arduino Nano in the front are only used to drive the Screens, they are not connected to the host computer except to modify the programs (sketches) running on them.įlip the DSKY and connect the USB cable to the large Arduino Mega on the back. Once the Arduino Software has been installed, it is time to plug in the DSKY so it gets assigned a serial port number. Or for a direct link to the English version:įollow the instructions for your operating system to install it.Ģ) Connect Arduino Mega on back of DSKY to host computer. and click on the 'Software' button on the bar at the top of the screen If the Arduino Software is not installed, download it from: If there is any version of the Arduino Software installed on the computer, this step can be skipped. To function properly, the DSKY needs the Arduino Serial Port drivers installed in the host computer. If prompted, save all the zip files to your Downloads folder, which should look like this:įor more information on the Dual Scrren Apollo DSKYġ) Install Arduino Virtual Serial Port Drivers. The next step is to download the zip files for the following three projects, direct links to the zip files can be found below, all links open in a new window: This is generally an uncomplicated step that involves downloading the appropriate software from the Arduino website: Here are the instructions to setup an Arduino IDE to successfully compile the source code for the Dual Screen Apollo DSKY and other Arduino sketches that use the GPIO fast pin library and/or the FastSeedTFTv2 graphics library for the Seeed TFT Touch Shield v2įor more information on the Dual Scrren Apollo DSKY: